Make sure that the (blue) Wi-Fi lamp on the printer is also lit.If any of the following error codes are displayed on the LED (alternately flashing between the letter “E” and then a “Number” followed by another “Number”), please press the or button to dismiss the error, and then repeat steps 1 and 2.This error appears when wireless connection setup was not completed within 2 minutes after pressing the WPS button.Is the access point turned on? If the access point is already turned on, turn it off, and then turn it back on.This error appears when multiple WPS access points are detected. When wireless connection is complete, the LED lights up for about 3 seconds, then changes to "1" as shown in the illustration below. Make sure that the LED flashes as shown in the illustration above, then press the button on your access point within 2 minutes.For exact details regarding pressing the WPS button, please refer to the access point manual.The (blue) Wi-Fi lamp on the printer will flash while searching for, or connecting to the access point.3. Make sure that the LED flashes as shown in the illustration below.2. Press and hold the button (A) on the printer for approximately 5 seconds.2.
Canon Ij On Screen Download The ManualsWindows 8 users - double-click. Insert the CD that came with your printer & run the setup.Windows Users – If the “Setup CD-ROM” does not autorun, insert the CD-ROM into the computer again and click on , select the CD-ROM and double-click. Press the button or the button.When referring to the printout, check that the “Link Status” indicates “Active” and that the SSID - Service Set Identifier (the name of your wireless network) indicates the correct name of your wireless network.Please now proceed by installing the software to make the most out of your PIXMA MG3250.If you do not have the installation CD that came with your product, please download the manuals and software to continue.If the WPS wireless setup is still failing after following this guide, please contact us for further assistance.1. Press the button (A) repeatedly until the LED displays4. Load a sheet of A4 or Letter-sized plain paper.3. Make sure that your printer is turned on.2.Select for a connection method.4. When the initial screen appears, click on. When the selection window opens, click the to start the software download link.If you do not have the installation CD that came with your product, you can download the manuals and software to continue.2. Mac Users – Double-click the icon mounted on your desktop.![]() ![]() When the following screen appears, click on. Make sure that the LED flashes as shown in the illustration below.4. Press and hold the button (A) on the printer for approximately 5 seconds.3. Download nissan mapIf you’re not sure which software you want to install at this stage, don’t worry, as you can always uninstall it at a later stage if you wish.2. When the following screen appears, select the software you wish to install, and then click on. When the following screen appears select your language, and then click on. If this is the wireless network you want your printer to connect to, click on. The name of the access point that your computer is connected to will be displayed (where “xxxxxxxxxxxxx” is shown). Once your printer has been detected, the following screen will appear. This is the cable with the symbol on the connector.5. When the following screen appears, connect your printer to your computer using the supplied USB cable. When the following screen appears, click on. If the wireless setup is still failing after following this guide, please contact us for further assistance. The following screen indicates the model of your printer and the name (or SSID) of your wireless network.In the following screen, select the driver version and click. When the following screen appears, disconnect your printer from your computer and click.
0 Comments
Leave a Reply. |
AuthorMaria ArchivesCategories |